Idis DC-B1001, Руководство по эксплуатации

Страница: 29 / 58

Part 3 - Remote Setup
29
• Shutter Speed Control : Adjust Shutter Speed.
This option is available only when Anti-Flicker and
Slow Shutter are both set to Off .
- Auto : The system will assess the lighting
conditions and adjust the shutter speed
automatically.
- Manual : Use the slider to select the desired
shutter speed. Select the most suitable minimum
and maximum shutter speeds for the lighting
conditions in the area where the camera is
located.
With certain features, selecting Auto automatically
loads settings suitable for the camera's installation
environment.
Day & Night
Not applicable to DC-B1001 / DC-B1101
Configure
Day & Night
settings.
• B&W Mode : Display the images in greyscale for
greater clarity in low-lighting conditions. When
configuring
Event > Alarm In , this feature will not
function if
Day & Night Mode
event action has
been configured.
- On/Off : Enable/disable B&W Mode.
- Auto : Allow the system to enable/disable B&W
Mode automatically.
- Schedule : Set up a B&W Mode schedule. B&W
Mode is enabled on days and times designated
as
Nighttime and disabled at all other times.
Select On or Off at the bottom of the schedule
table and then click or drag on the dates and
times to select/unselect as
Nighttime
. Select
On or Off and then click Select All/Clear All to
select/unselect all dates and times as Nighttime.
With DC-B1001 / DC-B1101 model, B&W Mode
can be configured from the Image Sensor screen.
For more information on Image Sensor settings,
refer to the
Image Sensor on page 27.
• IR Cut Filter : IR Cut Filter blocks out the infrared
spectrum. You can ensure clear images at all
times by blocking out the infrared spectrum in
high-lighting conditions and allowing the infrared
spectrum to pass through in low-lighting conditions.
When configuring
Event > Alarm In , this feature will
not function if Day & Night Mode event action has
been configured.
DC-B1103 / DC-B1203 only
- Daytime Mode / Nighttime Mode : Disable or
enable IR Cut Filter.
-
Auto
: Allow the system to enable/disable IR Cut
Filter automatically.
- Schedule : Set up an IR Cut Filter schedule. IR
Cut Filter use is disabled during dates and times
designated as
Nighttime and enabled at all other
times. Select On or Off at the bottom of the
schedule table and then click or drag on the dates
and times to select/unselect as
Nighttime . Select
On or Off and then click Select All/Clear All to
select/unselect all dates and times as Nighttime.