Operator Manual ilex with IPS500A
L280-0688 REV C
Operating Instructions to remove cable:
1.
Push downward on blue cam’s tapered end until cam
is clear of cable.
2.
Remove cable from groove of grey base.
7.
Batteries
The ilex system is designed to be used when powered with a hospital grade AC outlet. Battery
backup to elevate the monitor is available for emergency or transportation only. When AC
power is applied, the actuator backup battery will begin charging until the battery reaches full
capacity at which time, the charging will taper off. If the unit loses AC power, the monitor
elevation function will automatically switch to battery back-up mode. An audible tone is
sounded when using an operator control function if the battery charge is low.
Batteries are located inside the control box.
Local procedures may be in place for proper disposal or recycling of batteries.
For more information about batteries, such as battery life, production codes and disposal, see the
WARNING
Actuator Batteries are
not
automatically maintained to
original maximum charge requiring periodic testing
and replacement if necessary.
CAUTION
Batteries are not to be changed by the operator.
Refer to authorized technician.
Push up to install cable
Press down to release cable
