Idex LIQUID CONTROLS HML210, Руководство по установке и эксплуатации

Страница: 42 / 44

42
Display Rotation
Appendix
Remove the two screws which fasten the board in place
as indicated in Figure 1.
Lift the board and remove the flat cable from the display
as indicated in Figure 2. Remove the board from the
enclosure.
Remove the screw in the display to allow the board to be
tilted to extract the display as indicated in Figure 3.
Rotate the display to the desired location, verify the
correct location of the seal, clean the contact surfaces,
and set the display in the housing.
Tilt the display is a suitable orientation and fasten with
the screw.
Tighten the screws in the order as indicated in Figure 4.
Reconnect the flat cable to the display. Verify the correct
location of the board in the retaining clip and finish the
assembly by fixing the board to the box.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5