VISIBILITY DELIVERED.
PAGE 6 OF 15
2
Safety Precautions
Important Safety Note
The devices described in this manual are for exclusive operation by trained employees. Only qualified
personnel that know the potential dangers involved should perform the installation, settings, maintenance and
repair of the units used.
Operational Safety
The correct and safe use of these systems assumes that operating and service personnel follow the safety
measures described in the manual alongside the generally acceptable safety procedures.
If there is a possibility where a safe operation cannot be guaranteed, the system must be switched off and
secured against accidental use. Then, the service unit responsible must be informed.
Do not open the housing
There is no need to open the housing. There are no user serviceable parts inside. Set-up and configuration
during initial operation is done wireless with the built-in air interface.
Handling Safety
In the event of high operating temperature of 70 °C (+158 °F), the tags are heated and must be handled with
care. To prevent burns, wait until the tags have cooled down or use appropriate gloves. At temperatures
below 0 °C (+32 °F) tags can be frozen. In this case, wait a while until tags are warmed up or use
appropriate gloves.
Battery Inside
All tags contain a battery. That is the reason for the following instructions:
Warning
Fire, explosion and burn hazard
Risk of explosion if battery is replaced by an incorrect type
Do not recharge, short circuit, crush, disassemble, heat above 70 °C (158 °F)
Do not incinerate, or expose contents to water
Electrostatic Discharge
This product contains components that are sensitive to electrostatic discharges. Please observe
the special instructions for their protection. Incorrect handling can damage the unit and cause the
invalidation of the warranty.
Safety Documents
This ILR system was designed, tested and supplied in perfect condition according to the test report document
EN60950.
Condensation/Change of Temperature
Moving the systems from a cold to a warm environment could lead to dangerous situations due to
condensation. Therefore it must be ensured that the system can adjust itself to the warmer temperature.
