Page 16 of 17 5/11/2012
g.
You will hear a long beep from the auto-dialer to confirm that learn was
successful and the screen will display FULL for that zone.
h.
Press the
PROG
button seven (7) times to exit the setup mode.
NOTE:
if you have learned a motion detector to your auto dialer, place a towel over the
motion sensor before learning other items as the motion sensor will send signal to auto-
dialer every time you move.
ADDING IDEAL’S WIRELESS SIREN OR AC OUTLET TO THE SYSTEM
LEARN AUTO DIALER TO SEND SIGNAL TO WIRELESS SIREN (SK629) OR
AC OUTLET CONTROL (SK635) WHEN TRIGGERED.
When the auto-dialer is triggered you may want it to send a signal to either a siren or an AC
outlet control (will turn on unit that is plugged into it)
SK629 SIREN (Full instructions are also available in the SK629 package)
f.
Open the battery cover on the back of the siren. Use a pen to press and hold down
the
LEARN
button for 2 seconds, you will hear a beep. Release the button. The unit
is now ready to receive the learn ID code signal from the auto dialer.
g.
Trigger the auto dialer by pressing on the panic button.
h.
Once learn code was successful you must ARM the siren in order to receive the
signal from the auto-dialer. Their will be a
60 second
delay at which time you will
hear a beep. Now it will be ready to receive signal.
SK635 AC OUTLET CONTROL
1.
Press and hold the
ON/OFF/LEARN
button on front of unit for 2 seconds
until you hear a beep. Now the unit is ready to learn signal.
2.
Trigger the auto dialer by pressing on the panic button.
3.
Once learn code was successful you must turn ON the AC Outlet Control in
order to receive the signal from the auto-dialer.
NOTE:
You will hear a long beep to confirm that the learn code was successful. When
learn code is not successful you will hear 4 short beeps. If this happens please relearn again.
TROUBLE SHOOTING GUIDE
