Page 13 of 17 5/11/2012
6. REMOTE CONTROL BY TELEPHONE TO CONTROL ALARM (To control
your auto dialer via telephone)
a.
Telephone your home number. The auto-dialer will answer after the designated
amount of rings that you have programmed.
b.
Once answered enter your PASSWORD, you will hear two beeps (confirmation).
c.
Enter key combination listed below for desired function you would like to perform.
Function
Press Key
Room Monitor
1#
ARM system
5#
DISARM System
6#
ROOM MONITOR
– Enter “1#” after the beep you will be able to listen into the room
were the auto-dialer is installed. After 30 seconds you will hear a beep to remind you that if
you do not enter another code within 20 seconds the call will end. The total duration of the
room monitor is 50 seconds if no other codes are entered.
ARM SYSTEM
– Enter “5#” after three short beeps the system is ARMED and will
automatically hang up. If you hear 5 rapid beeps after three short beeps, it means one of
your sensors isn’t closed or is activated. The system will give you 5 seconds to DISARM
system.
DISARM SYSTEM
– Enter “6#” after a beep the auto-dialer will disarm and hang up.
NOTE: Whether you receive an alarm call or you call the auto dialer, if you enter a
wrong password or operation code, the call will disconnect and sound 5 beeps on the
auto-dialer. If the call was an alarm call to you, in which case you can wait for it to
call you again providing you have the dialing sequence set to more than one and then
enter the above codes again. If your dialing sequence is set to one and you have set up
the auto dialer to answer before your answering machine (if you have one connected)
then you can call into the auto dialer and enter in your codes again. If you made the
initial call to the dialer you just have to redial and then enter the codes above again.
HOME MODE FUNCTION:
While at home you can set your auto-dialer to home mode. This will activate a chime every
time one of the sensors is triggered. You can also program which zone will send signal to
auto-dialer when triggered. The factory default is all sensors send signal.
Turn system to Home Mode.
a.
Press the HOME button once; you will hear a chime and the word HOME will
appear on the LCD screen.
b.
Wait 60 seconds, you will hear a beep. System is now in home mode and will chime
if sensor is triggered.
c.
When auto-dialer receives signal it will chime and show which zone is being
triggered on the auto-dialer LCD screen. If 24hr or panic is triggered the auto dialer
will start dialing the numbers programmed for the amount of times specified.
d.
Press the home button again to exit the home mode.
