IDEAL INDUSTRIES UniPRO MGig1, Руководство пользователя

Страница: 28 / 68

152810 UniPRO
Page 28 User Guide
Remote control
MGig1 to MGig1
A second MGig1 can be set in slave mode. In
slave mode, MGig1 can replicate a SEL1 and be
used as a loopback unit, or it can be remotely
configured and used as a second tester in bi-
directional tests – see
Transmission testing
concepts, General,
on
page 14
.
To put the second MGig1 in Slave Mode:
From the home screen select TESTS and then
select the SLAVE icon. Select RUN (F1) to enter
Slave Mode (Fig 31). This MGig1 is now the slave.
From the master MGig1:
Select SETUP>TARGETS and the ‘Targets’ screen
is shown on the display. Select ADD (F1) and a
pop up dialog gives you the choice of searching for
IDEAL targets or to configure the search manually.
Select SEARCH from the pop up dialog and after a
scan the ‘Discover’ screen is shown on the display.
Highlight the MGig1-Slave and select SELECT
(F3). The ‘Target #’ screen is shown on the
display. Select APPLY (F3) and the tester returns
to the ‘Targets’ list which now includes the recently
discovered MGig1 (Fig 32).
For Bi-directional tests you must set the slave
MGig1 to ‘No Loop’ as follows:
Select SETUP>TARGETS, the ‘Targets’ screen is
shown on the display.
Use the arrow keys to navigate to the slave MGig1
and select EDIT (F3), the ‘Target #’ screen is
shown on the display (Fig 33). Select No Loop
from the dropdown list and then select APPLY (F3).
NOTES
1. When MGig1 is in slave mode and used as
a loopback device, it can be remotely
configured in the same way as a SEL1. See
MGig1 to SEL1
on
page 29
.
2. To exit slave mode select the MASTER
icon.
Fig 31
Fig 32
Fig 33