______________________________________________________________________
Co
Brite
User Manual
20
A flashing laser selection button indicates that the laser is currently tuning.
5.1
Settings Laser
T
ouching “Settings laser x” button or the central current status field will open a popup allowing
to set the laser parameters.
Select the parameter to be changed by touching on the corresponding button. The current
parameter setting is displayed in the field below. Change the setting by swiping the
corresponding roll bar to change each digit or use the horizontal slider for coarse tuning. If a
value exceeding the limits of the laser is dialed in, the limits will be shown and the ok button will
be disabled. Move the setting back to a valid setting or cancel the popup.
Once the new setting is dialed in, proceed
to the next parameter or press “ok” or switch to the
next laser port to be set
by pressing the Laser “x” button located on the upper left side. The
laser will be subsequently tuned to the new setting. The tuning process is indicated by a flashing
of the port overview located at the right-hand side. The base unit for the laser
Wavelength/Frequency can be changed in the “Device Setup” popup.
In Frequency mode, a touch button “Grid” is displayed that allows applying a virtual Grid to the
Frequency roll bar. With this, the minimum increment of the laser frequency equals the grid
value set. Note that this feature will not alter the settings of the laser port itself but eases the
