ICT Protege, Руководство по настройке

Страница: 11 / 38

Keyslot Availability
Keyslot Description
0 Card Settings Lock Login
1 OSDP Session Key
2 Available
3 Available
4 Available
While slots 0 and 1 can be used if not required for the card settings lock login or OSDP session key, it is
recommended to avoid using these keyslots to prevent potential future issues if the configuration changes.
LED Mode
Set the reader to use either normally blue, normally green or dual LED mode.
The default setting is single LED mode, normally blue.
⦁ LED Mode :
- Dual : Allows the signaling of both LEDs independently using the LED control lines
- Blue : Blue LED is on by default
- Green : Green LED is on by default
Dual LED mode requires the reader to be wired with both the orange and brown LED control lines connected.
Backlight Level
Set the brightness of the keypad backlight (for readers with keypads).
⦁ Backlight Level :
- Disabled
- Very Low
- Low (default setting)
- Medium
- High
- Very High
Device Mode
The Device Mode TLV is used to factory default the reader or put it into an update mode.
The device mode must be the first TLV in the config, so when you add this TLV it will be automatically placed
above any other TLVs programmed previously.
⦁ Device Mode :
- Firmware Update Mode : Put the reader into boot mode so that new firmware can be loaded.
- Factory Default EEPROM : Default the reader back to its shipped factory default configuration.
This cannot be undone . Once the reader is defaulted you will need to reapply all configuration
programming.
- OSDP Install Mode : Put the reader into OSDP installation mode so that it is ready to accept initiation of a
secure channel session from the connected controller or module.
ICT Card Reader | Configuration Guide 11