PRT-RDM2-PCB
Protege Mini 2 Reader Expander
Installation Manual | March 2015
21
11
European CE and EN 50131
European Standards
Conforms to European Union (EU) Low Voltage Directive (LVD) 73/23/EEC (amended by 93/68/EEC) and
Electro-Magnetic Compatibility (EMC) Directive 89/336/EEC (amended by 92/31/EEC and 93/68/EEC). The CE
mark indicates that this product complies with the European requirements for safety, health, environmental and
customer protection
This component was tested by the accredited testing laboratory No. 1172 of the company TESTALARM Praha
s.r.o. and met the requirements and conditions for full compliance with EN50131 series of standards for
equipment classification;
Security Grade 3
Environmental Class II
Equipment Class: Fixed
EN 50131
-1:2006, EN 50131-3:2009, EN 50131-6:2008
Recognition class 2 (for readers without a keypad)
Recognition class 3 (for readers with a keypad)
Access class B
EN 50133-1:1998
ICT enclosure all products, CAB-JMB-NOT, has been tested and certified to EN50131. By design, the ICT
enclosure for all products, CAB-FBY-NOT, complies with the EN50131 standards. Tamper protection against
removal of the cover as well as removal from mounting is provided by tamper switch.
Warning:
Enclosures supplied by 3rd parties may not be EN50131-compliant, and should not be claimed as such.
EN 50131
In order to comply with EN 50131-1 the following points should be noted:
Ensure for Grade 3 compliant systems, the minimum PIN length is set for 6 digits.
To comply with EN 50131-1 Engineer access must first be authorised by a user, therefore Installer codes will
only be accepted when the system is unset. If additional restriction is required then Engineer access may be
time limited to the first 30 seconds after the system is unset.
Reporting delay –Violation off the entry path during the entry delay countdown will trigger a warning alarm. The
warning alarm should not cause a main alarm signal and is not reported at this time. It can be signaled locally,
visually and or by internal siren type. If the zone is not disarmed within 30 seconds, the entry delay has expired
or another instant is violated, the main alarm will be triggered and reported.
To comply with EN 50131-1 neither Internals Only on Part Set Zone Alarm nor Internals Only on Part Set
Tamper Alarm should be selected.
To comply with EN 50131-1 Single Button Setting should not be selected.
Anti Masking
To comply with EN 50131-1 Grade 3 for Anti Masking, detectors with a separate or independent mask signal
should be used and the mask output should be connected to another input zone.
I.e. Use 2 input zones per detector. One zone input for alarm/tamper and one zone input for masking.
To comply with EN 50131-1:
do not fit more than 10 unpowered detectors per zone,
do not fit more than one non-latching powered detector per zone,
do not mix unpowered detectors and non-latching powered detectors on a zone.
