5. Setting up the device
16
Menu level
Parameterisation level
Display values for supporting points,
dIS.01 … dIS.30:
Under this parameter supporting points are defined according to their value. At the sensor
calibration, like at final value/offset, one is asked at the end if a calibration shall be activated.
Analog values for supporting points,
InP.01 … InP.30:
These supporting points are displayed at works setting (4-20 mA) only. Here, demanded analog
values can be choosen freely. The input of steadily rising analog values needs to be done self-
contained.
Display underflow,
dI.Und:
Default:
-19999
With this function the device undercut (
_ _ _ _ _
) can be defined on a definite value.
Display overflow,
dI.oue:
Default:
-19999
With this function the device overflow (
- - - - -
) can be defined on a definite value.
Input variable of process value,
SIG.in
:
Default:
a.meas
This parameter controls the device via the analog input signals
a.meas
=
Sens.f
repectively
fre9u
or via the digital signals of the interface
M.bus
= RS232/RS485 (Modbus protocol). Confirm the
selction with
[P]
and the device changes back into menu level.
Back to menu group level,
rEt:
With
[P]
the selection is confirmed and the device changes into menu group level
„–INP–“
.
