ICS Advent 586MBHP Series, Руководство по эксплуатации продукта

Страница: 22 / 72

Manual Number: 41209-003-2 Page 1-8
586MBHP Series Manual
Installing Memory Modules
The 586MBHP has 4 memory module sockets. The order in which they should be populated is
from the inside of the board outward. Note that each socket is labeled: SM1,SM2,SM3,SM4.
Refer to figure 1-4.
IMPORTANT
At least TWO memory modules MUST be installed at a time.
When inserting the memory modules, note the notch on the edge of each module. This notch is
designed to permit insertion in only one way. This notch must be pointed towards the keyboard
connector.
Start with the innermost socket (SM1). Gently place the module into the desired socket at a
30-45-°angle. Then gently rotate or rock the module into an upright position. Never force a memory
module into its socket. Rather, double check the notch and gently rock it into place. When the
module has been properly installed, the metal latches on either side of the memory module will
“click” into place. (See figure 1-3). Repeat the mentioned steps until all memory modules are
installed. No jumpers are involved in DRAM configuration.
Figure 1-3: SIMM Insertion
Gently place the SIMM
into the desired socket at 30
°-45 ° angle.
Then gently rotate or rock
the SIMM into an upright
position. Never force a
SIMM into its socket.
Double check the notch and
gently rock it into place if
properly installed the SIMM
will “click”.