ICP RS Series, Руководство пользователя, Страница: 98 / 193

98
Step 1 - Create an ICP Windows 2000 driver disk.
You need a 3.5" HD formatted floppy disk. Create from the ICP System CDROM the ICP
Windows 2000 driver disk (you can copy file by file or write an image). If you copy file by file
do not use the Explorer , because it may not copy all files from the ICP System CDROM.
Note: You cannot use the ICP Windows NT driver disk for installing Windows 2000.
Step 2 – Enabling the CDROM Boot for a SCSI CDROM on the ICP Controller
(Note: This step is not necessary if you boot the Windows 2000 CD from a CDROM which is not
controlled by the ICP Controller).
Load ICPCON and press F4 for the Advanced Setup Mode. Select the Configure Controller
menu and enable the CDROM-Boot.
F.3.2 The Installation
First of all, make sure that you have verified or carried out all steps described in sec-
tion F.3.1.
F.3.2.1 The ICP Controller is the first Controller in the System
The following instructions 1.) to 6.) assume that the ICP Controller is the first controller in
the system and that the operating system is booted from its first Host Drive.
We recommend you to install Windows 2000 through booting the Windows 2000 CD
and not using the floppy disks.
1. Boot the Windows 2000 CD.
2. After the setup screens comes up press
F6
3. Select:
S=Specify Additional Device
4. Insert the ICP Windows 2000 driver disk.
5. Select the
ICP GDT Disk Array Controller
and press ENTER.
6. Continue with the Installation and follow the Windows 2000 Setup program.
F.3.2.2 The ICP Controller is the second Controller in the System
To install an ICP Controller in an already running Windows 2000 system, you may either
follow the instructions of the installation wizard, who has detected the ICP Controller dur-
ing the boot process, or use the Control Panel.