35
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33/66 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver
(Windows 95 OSR2 or a third-party IDE bus master driver). If your hard
drive and your system software both support Ultra DMA/33/66, select
Auto to enable BIOS support.
The Choice: Auto, Disabled.
Init Display First
This item allows you to decide to active whether PCI Slot or on-chip VGA
first
The choice: PCI Slot, Onboard , AGP
KBC input clock
This item is keyboard controller input clock option.
The choice: 6, 8 ,12, 16 MHz .
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install and-in FDC or
the system has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
Select a operation mode.
The choice: IrDA, ASKIR, Normal.
UART2 Duplex Mode
Select a UART2 speed mode.
The choice: Full, Half.
36
RxD , TxD Active
Select a RxD, TxD active level.
The choice: Hi,Hi, Hi,Lo, Lo,Hi, Lo,Lo
Onboard Parallel Port
Select an address and corresponding interrupt for the parallel port.
The Choice: 3BC/IRQ7, 378/IRQ7, 278/IRQ5, Disabled.
Parallel Port Mode
Select parallel port Mode.
The Choice: SPP, EPP, ECP, ECP+EPP.
ECP Mode Use DMA
Select a ECP mode used DMA channel.
The choice: 1, 3.
EPP Mode Select
Select a EPP mode.
The choice: EPP1.7, EPP1.9.
