19
3.14 Power LED Connector
The pin assignments are as following
CN26 : Power LED Connector
1
2
PIN NO.
DESCRIPTION
1 LED
+
2 LED
-
z
z
20
4
BIOS Setup
4.1 Introduction
This chapter discusses Award™ Setup program built into the ROM BIOS.
The Setup program allows users to modify the basic system configuration.
This special information is then stored in battery-backed CMOS RAM so
that it retains the Setup information while the power is off.
4.2 Starting Setup
The BIOS is immediately activated when you turn on the computer.
While the BIOS is in control, the Setup program can be activated in one
of two ways:
1. By pressing <Del> immediately after switching the system on, or
2. by pressing the <Del> key when the following message appears
briefly at the bottom of the screen during the POST (Power On Self-
Test).
Press DEL to enter SETUP.
If the message disappears before you respond and you still wish to enter
Setup, restart the system to try again by turning it OFF then ON or
pressing the "RESET" button on the system case. You may also restart
by simultaneously pressing <Ctrl>, <Alt>, and <Delete> keys. If you do
not press the keys at the correct time and the system does not boot, an
error message will be displayed and you will again be asked to...
PRESS F1 TO CONTINUE, DEL TO ENTER SETUP
