41
IDE Prefetch Mode
The onboard IDE drive interfaces supports IDE prefetching for faster drive
accesses. If you install a primary and/or secondary add-in IDE interface, set
this field to
Disabled
if the interface does not support prefetching.
The choice: Enabled, Disabled.
Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO
mode (0-4) for each of the four IDE devices that the onboard IDE
interface supports. Modes 0 through 4 provide successively increased
performance. In Auto mode, the system automatically determines the
best mode for each device.
The Choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
Primary/Secondary Master/Slave UDMA
Ultra DMA-33/66/100 implementation is possible only if your IDE hard
drive supports it and the operating environment includes a DMA driver
(Windows 95 OSR2 or a third-party IDE bus master driver). If your
hard drive and your system software both support Ultra DMA-
33/66/100, select Auto to enable BIOS support.
The Choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
Init Display First
This item allows you to decide to active whether PCI Slot of VGA card first.
The choice: PCI Slot, Onboard, AGP .
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or
multiple sector read/write. If your IDE hard drive supports block mode
(most new drives do), select Enabled for automatic detection of the
optimal number of block read/writes per sector the drive can support.
The choice: Enabled, Disabled
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
and-in FDC or the system has no floppy drive, select Disabled in this
field.
42
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled,
Auto.
UART 2 Mode
This item allows you to select which mode for the Onboard Serial Port 2.
The choice: Standard, HPSIR, ASKIR.
IR Function Duplex
This item allows you to select the IR half/full duplex funcion.
The choice: Half, Full.
TX ,RX inverting enable
This item allow you to enable the TX, RX inverting which depends on
different H/W requirement. This field is not recommended to change its
default setting for avoiding any error in your system
The choice:
No, No/ No,Yes(Default)/ Yes, No/ Yes, Yes.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O
address setting.
The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled,
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible,
or
SPP
unless you are certain your hardware and
software both support one of the other available modes.
The choice: Normal, EPP, ECP,ECP/EPP
ECP Mode Use DMA
Select a DMA channel for the parallel port for use during ECP mode.
The choice: 3, 1.
Parallel Port EPP Type
elect EPP port type 1.7 or 1.9.
