EC2-DIO series EtherCAT Slave I/O module
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
-
18 -
3.
Getting Started
This chapter provides a basic overview of how to configure and operate your EC2-DIO series
module.
3.1
Connecting the Power and the Host PC
Step 1
Connect both the IN port of EC2-DIO module and RJ-45 Ethernet port of Host PC.
Ensure that the network settings on the Host PC have been correctly configured and are functioning
normally.
Ensure that the Windows firewall or any Anti-Virus firewall is properly configured to allow
incoming connections, or temporarily disable these functions.
Step 2
Apply power to the EC2-DIO module
Connect the Host device to the
IN Port
on EC2-DIO module.
Connect the
24V pin
to positive
terminal on a
+10 ~ +30 V
DC
power
supply
, and connect the
GND pin
to
the
negative terminal
.
NOTE: Attaching an ESC (EtherCAT Slave Controller) directly to an office network will result in
network flooding, since the ESC will reflect any frame – especially broadcast frames – back into
the network (broadcast storm).
IN
DC
Ethernet Cable
OUT
