Page 9
Designed to use standard 40mm swimming pool PVC piping.
The iCool system is designed to
connect with the industry standard 40mm swimming pool and spa water pipes and fittings. Any regular pool supply
company can provide these.
Attach the water manifolds as shown.
The water manifolds have been removed for safe shipping. Attach
them by screwing them on as tight as you can by hand. Do not use a wrench or you may damage the fittings.
Manifolds can be reversed if water pipe connections are required in the opposite direction, but the water always
flows in to the bottom manifold from the pool and out from the top manifold back to the pool. Standard “40mm PVC
Pressure” pipes should be used. Do not use smaller pipes or the flow will be too restricted.
All pipework must be well
insulated.
iCool can provide details of suppliers of ideal, easy to install, 90 mm diameter foam insulation.
Please make sure that these rubber “O” rings are in place or the connection will leak.
Electrical Connections:
Because iCool equipment is shipped to many countries, your TurboCool is normally
not supplied with an AC power plug. You must connect the heavy duty power cable provided in a manner that is
legal and safe in your country. A 220 volt unit requires a minimum 15-20 amp single phase connection and a 110 volt
unit requires a minimum 30-40 amp connection. The safest and best way to connect your TurboCool is to a wall box
with an isolation switch, however, because the iCool also has an isolation safety switch and an earth leakage safety
device built in, you can also simply attach a power plug and plug that into a standard wall socket.
Connecting the Pump:
Depending on your order, on the rear of your TurboCool there will either be a standard
AC power socket or a splash proof connection box to connect the water circulating pump. If it has a power socket
you can simply plug the pump in. Otherwise follow the connections as set out below.
You must connect the pump here or the TurboCool can not provide safety monitoring or control it’s function.
The BROWN wire is the ACTIVE
The BLUE wire is the NEUTRAL
The GREEN wire is the EARTH
This is the main power cable.
The water pump must be connected to the
waterproof switch box on the rear panel of the
TurboCool. Inside the switch box are three wires
and suitable screw connector fittings
Pump Size:
If you are supplying your own pool pump
it must not be more powerful
than 450-500 watts. Never run a high power spa jet pump in to your iCool. If you
need massage jets you must use a seperate plumbing circuit for them.
Higher power
pumps, such as standard swimming pool pumps, can damage the heat exchangers
and plumbing seals in your TurboCool. Please contact iCool for the correct advice on
your particular pump installation if you are unsure.
Mains Wiring Code
:
iCool uses the international colour code for AC electrical wiring. The
BROWN
wire is the
ACTIVE, the
BLUE
wire is the NEUTRAL and the
GREEN
wire is the EARTH.