Page 3
Please read before operating.
Power Supply Voltage
iCools can only be connected to the voltage marked on the machine. They are
manufactured as either 110v or 220v machines, but they are
not multi voltage.
The
applicable voltage is marked next to the main power switch. Using a different voltage
may cause severe damage.
All models can be used on both 50 Htz and 60 Htz AC supplies.
An Approved Earth Connection is Essential for Safe Operation.
To ensure safe operation the
AC power connection you use must have an earth connection that complies with your local electrical safety
regulations.
Built in Safety Systems
Your iCool has many essential safety features to protect against such things as
*A loss of water flow,
*Overheating of the system,
*Electrical shock risk.
If any such potentially dangerous situation should occur, in most cases your iCool will sound an alarm, shut itself
down and a red warning screen will appear to assist you to identify and correct the problem.
In the case of overheating, the main fans may continue to run for some time even after a shut down, until the
temperature is safely back to normal.
For the safety of users, any leakage of even a small amount of electrical current will instantly cause the Residual
Current Device to remove all electrical power from the entire system. The maximum leakage allowed is 30 milliamps
which is considered to be a generally harmless level.
Please Test the Earth Leakage Safety Device Regularly.
The main power switch is also part of the
electrical safety circuit that can prevent the possibility of electric shock. It is essential to test this safety system each
time you use the iCool to make certain it is operating correctly. This takes only a few seconds.
To Test the Earth Leakage Safety Device:
Turn on the main switch and then press the test button on the
switch body. If the safety system is working normally, pressing the test button will cause the main power switch to
shut off instantly. After a successful test, reset the main switch to ON to begin normal operation. If pressing the test
button fails to instantly shut off the power switch
DO NOT USE THE SYSTEM
until you contact iCool or a qualified
electrician for advice.
Never Restart Without Identifying And Correcting any Fault.
In the unlikely event that your system
shuts itself down for any reason, you must identify and correct the problem that has caused the safety system to
operate before allowing anyone to use the iCool
Electrical Power Connection.
Connect the power cable provided with your iCool to a standard power outlet
capable of providing at least 20 amps in countries with a 220 V supply and 40 amps in countries with a 110 V supply.
Actually the iCool requires much less power than this for normal operation, however all heat pump compressor
motors need considerably more power for up to a minute or so each time they start up and this must be allowed for.
The TurboCool can be connected either by attaching a suitable approved plug or by direct wiring into an approved
electrical wall box. An isolation switch is reccommended if connecting to a wall box.
Warnings: