ASSEMBLY
Assembly requires two persons.
Place the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until the treadmill is assembled.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt, the sides of the walking platform, or
the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt or
on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver and
rubber mallet .
For help identifying the assembly hardware, see the drawings below.
If a part is not in the parts bags, first
check to see if it has been preassembled.
3/4” Tek Screw (67)–6
1 1/4” Tek Screw (33)–4
3/4” Screw (87)–9
Latch Screw (70)–2
Pulse Bar Bolt (78)–2
3/8” Star Washer (15)–4
Upright Bolt (28)–4
Crossbar Bolt (77)–2
1. Identify the Right Upright (69) and the Left Upright (64) by
observing the positions of the indicated brackets.
Straighten the Wire Harness (98), and feed it into the
lower end of the Right Upright (69) and out of the hole in
upper end as shown in the inset drawing.
Hold the Right Upright (69) against the right side of the
Base (49), with the bracket on the side shown. Hand
tighten two Upright Bolts (28) with two 3/8” Star Washers
(15) into the Base and the Right Upright;
be careful not
to damage the Wire Harness (98). Do not tighten the
Upright Bolts yet.
With the help of a second person, carefully tip the tread-
mill onto its other side. Attach the Left Upright (64) as
described above. Note: There is not a wire harness on
the left side.
98
Brackets
64
1
69
49
28
15
98
69
6
