8
NXDN OPERATION <CONVENTIONAL MODE>
8-5
Transmitting a call (Continued)
Status call
D
The status call is a simple message function to transmit
and receive a status message. A transceiver can dis-
play the status message quickly. You cannot transmit a
voice signal at the same time.
Push [Status (NXDN)] to enter the Status Message
q
Select mode.
• Displays “STATUS.”
Push [UP] or [DOWN] to select a desired status
w
message.
• If you want to directly enter a status message, push [P2]
(MODE) to select the Status Message Entry mode.
You can enter a status message between 1 and 207.
• You can use the 10-keypad keys on the microphone.
STATUS
STATUS 001
Push [P3](TX) or [PTT] to send the selected Status
e
Message.
• Displays “SEND DATA” and then “COMPLETE.”
Short Data call
D
You can send a Short Data message of up to 100 char-
acters.
If you turn OFF the transceiver’s power, the message
is cleared.
Push [SDM (NXDN)] to enter the Short Data Mes-
q
sage Entry mode.
• Displays “MESSAGE?”.
MESSAGE?
Push [UP] or [DOWN] to enter a character, and then
w
push [P1](SET) to set.
• Goes to the next character entry position.
• You can use the 10-keypad keys on the microphone.
Repeat step
e
w
until you enter a message of up to
100 characters.
• Push [P0](DEL) to delete a character.
• Push [P2](
Ω
) or [P3](
≈
) left or right to select a charac-
ter.
SHORT MESSAG
Push [PTT] to send.
r
• Displays “SEND DATA” and then “COMPLETE.”
Push [P1](EXIT) to exit.
t
If you exit from the Short Data Message Entry mode,
and then you want to transmit the message again, do
the following steps.
Push [SDM (NXDN)] to enter the Short Data Mes-
q
sage Entry mode.
• Displays the entered message.
• Displays the last part of the message if the message is
over 12 characters.
HORT MESSAGE
Push [PTT] to send.
w
• Displays “SEND DATA” and then “COMPLETE.”
Push [P1](EXIT) to exit.
e
Long Data call
D
You can send a Long Data message of up to 4,096
characters only by using an external device, such as a
PC. You cannot send a message by pushing [PTT].
