5
8.8 PREDEFINED MESSAGES
Used to send a predefined system message.
To send a Predefined Message, push [F] then push
[A] or [B] until the selection is displayed, then enter
the target radio ID, push [D] and enter a message
number and push [#]. The target radio should send
and ACK if successful.
Figure 18 shows Message 2 ready to be sent to
366.
Figure 18
8.9 RADIO MONITOR
Used to key up a target radio from 10 to 60 sec-
onds
and monitor the transmit audio.
To monitor a radio, push [F] then push [A] or [B]
until the selection is displayed, then enter the tar-
get radio ID, push [D] and enter 1 (10 seconds), 2
(30 seconds), or 3 (60 seconds).
Figure 19 shows Radio Monitor request to 366 to
transmit for 30 seconds.
Figure 19
8.10 SBC LOG
To toggle the SBC Log ON, push [SHIFT] + [F],
to turn the log OFF, push [F]. When the SBC Log
is entered, the last SBC call is displayed. Push
[B] to scroll to the previous records and push [A]
to scroll to the end of the list. The radio will store
up to 99 log entries. When more than 99 entries
are made the oldest log will be deleted.
NOTE: When the radio is reset or reprogrammed,
all logs are deleted.
Figure 20 shows the fifth entry of the SBC Log.
Figure 20
9 P25 SQUELCH ADJUSTMENT
Push [SHIFT] + [MON] to choose the P25 squelch
mode.
Normal SQL = If NAC is the same, the receiver will
unmute
Selective SQL = If NAC and GROUP is the same, the
receiver will unmute
Figure 21 shows Normal SQ.
Figure 22 shows Selective SQ.
Figure 21
Figure 22
10 TALKGROUP ALIAS ID
When GPC is selected with the [A] key, the TGID alias
is indicated as programmed (Maximum 8 characters).
Figure 23 shows POLICE for the TGID alias.
Figure 23
Radio Monitor
To: 366
TX Mult :1 MD N
<SBC Log>
5: To: 00000366 F
Radio Monitor
TX Mult: 3
RX
TX
C001 TAC 2 MD N
Normal SQL
RX
TX
C001 TAC 2 MD S
Selective SQL
RX
TX
C001 TAC 2 MD N
GPC POLICE
Short Message
To: 366
Message :2 MD N
