Icom FR6000 Series, Руководство по продажам, Страница: 32 / 62

4-5 Remote Control Function
Connect the RS-232C terminal on PC and the D-Sub
25pin connector on the rear of IC-FR6000 by a cable.
Connection Connection Connection Connection
PC Command
PC Command PC Command
PC Command
The IC-FR6000 series has a D-SUB 25-pin accessory
connector for connecting LTR™/PassPort™ trunking*
controllers or other external devices. An operating
channel can be controlled by the input signal from the
D-SUB 25-pin connector.
A PC command protocol is available to the
manufacturers who produce external devices to
control Icom transceivers and/or repeaters by signing
an NDA.
Operation with a Hyper Terminal
Operation with a Hyper Terminal Operation with a Hyper Terminal
Operation with a Hyper Terminal
The Hyper Terminal software comes with Windows ®
2000 or Windows ® XP. Hyper Terminal software is
not supplied with Window Vista™.
Hyper Terminal setup Hyper Terminal setup Hyper Terminal setup Hyper Terminal setup
1. Name and Icon setup
When starting the Hyper Terminal software the
screen below will be displayed. Type a name and
select an icon from the list then click the OK
button.
2. Set up PC and radio connection
32
Setting of the Cloning Software Setting of the Cloning Software Setting of the Cloning Software Setting of the Cloning Software
•
Set the RS-232C mode at Common – Common
– RS-232C
Mode: MC CMD V2
•
The Initial set up value of connection Speed is
4800bps. This can be changed to match the speed
with the Terminal software.
2. Set up PC and radio connection
•
Select COM1 – COM2(255 max) of the “Connect
using”.
•
Detail of COM port setup
▒ NOTE
NOTE NOTE
NOTE Speed should be matched with cloning
▒ software settings.
Set each port setting parameter as below.
Data=8bit
Parity=None
Stop=1bit
Flow=None