ICM Controls SC2201, Инструкция по установке, эксплуатации и применению

Страница: 12 / 28

10
Changing Fahrenheit to Celsius
The temperature displays in degrees Fahrenheit as a factory set default. Follow these steps to change to degrees
Celsius:
Step 1:
Remove the cover.
Step 2:
Move the
F/C
jumper to the desired position,
F
or
C
using the center pin as a common.
Step 3: Press the Reset button once and reinstall the cover.
Your LCD readout changes accordingly.
Starting the Thermostat
Step 1:
Move the
Fan
switch into the
Auto
position.
• In Auto, indoor fan runs only during a heating or cooling cycle
• In ON, indoor fan runs continuously
Step 2:
Move the
Mode
switch in either
Cool
or
Heat
position, depending on the season.
The thermostat will now operate and maintain the room temperature at the desired
setpoint.
Note: When the thermostat operates the system, there is built-in compressor
protection. After the compressor turns off, the system will not turn it back
on for about five minutes. This protects the compressor.
Cool Off Heat Emer
Mode
Auto On
Fan