Installation
18
POSITIONING THE CONTROL PANEL
NOTE
The image of the control panel is only indicative as it may vary depending on the chosen model.
Proceed as follows to position the control panel:
–
Fit the relevant support (9) of the control panel present in the kit on the front crosspiece of the boiler
–
Position the control panel (10) on the support (9) and route the boiler regulation thermostat, safety, pump enabling and boiler
thermometer wires through the opening provided until reaching the bulb holder pockets (11) on the tube bundle.
–
Fasten the control panel to the support with the supplied screws
–
Complete the installation of the slats and closing profile (8) with the self-tapping screws supplied as standard.
9
11
10
8
BULB FASTENING
To achieve good thermal contact, it is necessary to use the retainer (1) to push the copper bulb (2) inside the pocket (3) screwed
in the sleeve (4).
Insert the clip (5) into the groove of sleeve (6) to avoid that the bulb slips out.
Each boiler is equipped with 2 retainers and 2 clips.
If a sleeve features 3 bulbs, the retainer is not required.
Cooke Industries - Phone: +64 9 579 2185 Email: [email protected] Web: www.cookeindustries.co.nz
