25
7. Essential measures to prevent freezing and bursting
Water inside the product gets frozen when ambient temperature is lower than 0℃(32℉)
and prevents the product from running properly. When the product is not in use for extended
periods such as winter, be sure to remove coolant and water completely from the inside
of the product as follows: Not removing all coolant and water will cause freezing and bursting,
which will critically damage the product. Freezing and bursting are not covered by the warranty,
incurring huge repair cost. Make sure to comply with the following.
Caution
1. Set the power switch to 'DRAIN' to completely
drain water from the ice maker.
(Up to 5 minutes)
2. Turn off the power and the circuit
breaker('OFF') and unplug the power cord
from the power outlet.
3. Remove the panels in the sequence of
top → front → left panels.
(Refer to 'How to disassemble the panels' on page 13)
4. Remove the water outlet hose clamp
of the evaporator cylinder, and then remove
the hose and wait until the ice inside the evaporator
cylinder completely melts.
(Compressed air gun may work efficiently
in removing water inside.)
5. Reassemble the water outlet hose to the evaporator
cylinder and attach the clamp back.
6. Assemble the panels in the sequence of
left → top → front panels.
Make sure to remove water from the water supply tank and the evaporator
NO
WATER
ICE
OFF DRAIN
TEMP
ERROR
MOTOR
ERROR
Clamp
Water outlet hose