icetro ID-0300-AN, Инструкция по установке и обслуживанию

Страница: 18 / 45

Detailed Operation
Sequence
Item Contents
Initial power-up.
ICE-OFF-WASH switch is in
The ‘Ice’ position.
1. Water inlet solenoid energized for 20 seconds for initial water reservoir fill.
2. Dump solenoid energized for 30 seconds & then water inlet solenoid energized for
10 seconds. (This occurs 3 consecutive times)
3. Gear motor is energized.
4. After 60 seconds of the gear motor being energized, the compressor & condenser
fan motor are both energized.
5. Ice begins to enter the ice hopper after 3 minutes of the compressor being
energized.
Ice Hopper Full
1. When bin switch opens for 2 consecutive seconds, the machine is recognized as
being full and the compressor & condenser fan motor are de-energized.
2. Gear motor continues to run for 60 seconds & is then de-energized.
Ice Hopper Low
1. When bin switch closes for 2 consecutive seconds, the machine returns to the ice
making mode and the gear motor is energized.
2. After 60 seconds of the gear motor being energized, the compressor & condenser
fan motor are both energized.
Water Inlet Solenoid
1. Energized when low level/high level float switch is in the NC (down) position.
2. De-energized when high level float is in the NO (up) position.
3. Triggers error code (Er15) when the high-level float is not detected after operating
for 60 seconds.
Gear Motor
1. Energized when the high-level float is detected.
2. Stops after a 60 second delay when bin switch opens.
3. After 1 hour of no operation, gear motor will energize for a 12 second agitation. This
will continue every hour until the bin switch closes and normal operation resumes.
Compressor
1. Energized 60 seconds after the gear motor is energized.
2. Stops immediately when the bin switch opens, indicating the ice hopper is full.
18