Ice TRICE 'Q', Пошаговая инструкция по сборке и руководство пользователя

Страница: 32 / 57

32
4.0 ICE Optional Accessories
4.1 Front mudguards
Assembly
The mudguards consist of three parts
• the mudguard bracket, which fastens to the trike
• the mudguard frame, which fastens to the bracket, and holds the plastic profile in place. These are left
and right handed.
• the plastic profile. This is pre-drilled to fit the frame
Begin by bolting the profile to the frame. The 3 drillings in the profile ensure that it can only be mounted one way.
A M5 x 12mm button-head bolt goes through the hole in the frame, a rubber washer is then placed on the bolt,
followed by the profile, the metal washer, and then the nylock nut. Tighten the nut snugly until the rubber washer
begins to compress. Do not over-tighten.
The bracket is then bolted to the frame. Using the M5x16 cap-head bolts with a metal washer on them, pass them
through the bracket and the frame as shown in the photo, and then fasten on the other metal washer and nut.
Tighten snugly (you will be adjusting this when you fit the mudguards to the trike)
Fitting
Front mudguards fit onto the steering pivots and can be quickly removed by one bolt in each unit.
To fit the mudguards, remove the bolt and washer from the top of the steering pivots and then clamp the
mudguards directly onto the top of the steering pivot re-using the bolt and washer.
TIP – The mudguard clamping bolts do need to be done up tight to prevent the
mudguards from pivoting round in use.
•
To remove a mudguard, loosen and remove the single clamping bolt and washer at the top of the steering
pivot on each wheel.
•
Cover the exposed mounting hole by re-fitting the bolt and washer.