Ice RS26L, Руководство оператора и каталог запасных частей

Страница: 8 / 41

8 ICE RS26L / RS28L / RS32L
OPERATOR MANUAL
mountInG tHe SQueeGee aSSemBly
1. Turn off the 1-Step switch and raise the
Squeegee assembly off the floor.
2. Mount the squeegee assembly to the squeegee
pivot bracket. make sure the knobs are
completely seated into the slots before securing
knobs.
3. Connect the Vacuum hose (machine
components, #42) to the squeegee assembly.
Loop the hose by using the hose clip provided.
4. Check the squeegee blades for proper
adjustment.
fIllInG tHe SolutIon tanK
The machine is equipped with a Hose fill-port
(machine components, #2) at the side of the
machine, and a bucket fill-port located under the
recovery tank.
NOTE: Before accessing the bucket fill-port
make sure that the recovery tank is empty.
When filling the solution tank with a bucket,
make sure that the bucket is clean. Do not use
the same bucket for filling and draining the
machine.
WARNING: Do not put any flammable
materials into solution tank. this can cause an
explosion or a fire.
fIllInG tHe deteRGent Bottle
The machine is equipped with a 6 liters Detergent
bottle (machine components, #22). Open the Cap
(machine components, #21) you can fill detergent,
and watch the liquid level on the Detergemt level
watching window (machine components, #16).
The ratio of water and detergent is 0~5%, you can
adjust this ratio via pressing the Detergent dosage
adjusting buttons (machine components, #29).
NOTE: Only use recommended cleaning
chemicals. Contact your janitorial supply
distributor for recommendations on
properchemicals.
WaRnInG: do not operate machine
unless you have read and understand this
manual.
pRe-opeRatIon cHecKS
1. Check the tank cover seals for damage.
2. Drain the recovery tank, check the vacuum fan
inlet filter, clean them if necessary.
3. Check the vacuum hose for debris or blockage.
4. Check the squeegees for damage, wear and for
deflection adjustment.
5. Check whether Pad/Bruch is installed properly .
6. Check the brakes and steering for proper
operation.
opeRatIon tHe macHIne
1. Sit in the Operator seat, adjusting the seat
to comfortable place by pushing the Seat
adjustment handle (machine components, #14).
NOTE: The machine will not travel unless the
operator is sitting in the operator seat.
2. Turn on the machine.
Check the LED display screen (machine
components, #31) , if there are fault codes
(machine components, #33) and the Fault
indicator (machine components, #32) is blink,
please Do Not operation the machine unless the
faults have been eliminated (please see FAULT
CODES AND ELIMINATE
section).
3. Select the preferred settings by pressing the
Brush pressure adjusting buttons (machine
components, #39) , Solution flow adjusting
buttons (machine components, #36) and
Detergent dosage adjusting buttons.
NOTE: Use the minimal pressure and flow
as possible.
4. Turn on the 1-Step switch, the Scrub head
assembly and the Squeegee assembly will
lower down automatically, all the presetting
functions will turn on.
5. The machine can scrub in both forward and
backward, place the Directional switch (machine
components, #26) in the forward direction is to
move forward, backward is to move backward.
The horn will sound and the squeegee will
raise automatically (the vacuum motor will turn
off after a short delay) when drive machine
backwards. This is to prevents damaging the
squeegee.
NOTE: Go slow when drive machine
backwards.
macHIne opeRatIon