Ice RS26L, Руководство оператора и каталог запасных частей

Страница: 10 / 41

10 ICE RS26L / RS28L / RS32L
OPERATOR MANUAL
BatteRy cHaRGInG tanK dRaInInG
dRaInInG tHe RecoVeRy tanK
Any time scrubbing is completed, or when refilling
solution tank, the recovery tank should be drained
and cleaned.
WaRnInG: If the recovery tank is not
drained when the solution tank has been
refilled, foam or water may enter the float shut-
off screen and cause damage to the vacuum
motor.
1. While holding the Recovery tank drain hose
(machine components, #40) upward, remove
the cap and lower hose to drain.
2. Open the Recovery tank cover (machine
components, #18) and rinse out the tank. Use
a rag to remove any excess dirt.
3. Remove and clean the vacuum fan inlet filter
located in the recovery tank. Clean the filter with
a damp cloth or low pressure water hose if dirty.
Allow the vacuum fan filter to dry completely
before reinstalling it in the machine.
dRaInInG tHe SolutIon tanK
Any time scrubbing operation is completed, the
solution tank should be drained and cleaned.
1. While holding the Solution tank drain hose
(machine components, #41) upward, remove
the cap and lower hose to drain.
2. Rinse the solution tank with clean water after
every use. This will help prevent chemical
buildup and clogging of the solution lines.
WaRnInG: fire or explosion Hazard.
Keep Sparks and open flame away. Keep
Battery compartment propped open When
charging.
Use only ICE supplied or apprved batteries
charger, use unapproved charger may cause
damage to the batteries and machine.
Batteries charger specifications:
• Applicable to charging Lithium-ion batteries
• automatic shut off circuit
• output current of 30 amps
• output voltage of 24 volts
1. Transport the machine to a well ventilated area.
2. Turn the machine off.
3. Prop up the Operator seat by the support stand
for ventilation.
4. Connect the charger's AC power supply cord to
a properly grounded receptable.
5. The charger will automatically begin to charge,
you can watching the charging status on the
window (machine components, #7), once the
charging cycle begins, the indicator lights will
progress from red, yellow to green. when the
green indicator light comes on, the charging
cycle is done. Unplug the charger cord.
NOTE: The machine will can not operate
when charging.