Ice RS26L, Руководство оператора и каталог запасных частей

Страница: 7 / 41

7 ICE RS26L / RS28L / RS32L
OPERATOR MANUAL
i-synergy
tm
collects operational data from
cleaning machines and transmit the information
to Ice’s server. the Ice server generates daily
reports and send them to designated end users
by email. From these reports, end users will
have information about machines’ usage and
even specific timings.
Besides, i-synergy
tm
also collects data on
lithium-ion battery, vacuum motor, brush
deck motor, transaxle, and other electrical
components at least once every minute when
the machine is in use and even during battery
charging.
i-synergy
tm
will send notifications instantly
to the Ice server in case of any malfunction.
Ice maintenance personnel will receive a
SmS within minutes from the Ice server for
immediate servicing.
uncRatInG macHIne
Be sure and check packing carton for any damage.
Immediately report any damage to carrier. Check
the contents of package to ensure that the
following items are included:
• Machine
• Lithium-ion Batteries
• Squeegee assembly
• 2-Pad drivers
1. Uncrate the wooden box, place the top board
on the edge of pallet, lie in the front of the
machine, as below shown.
WaRnInG: do
not operate machine unless
you have read & understood this manual.
2. Install batteries.(see INSTALLING BATTERIES )
3. Place the ID card on the scanning area (machine
components, #24) to turn on the machine,
make sure the Squeegee assembly (machine
components, #3) and the Scrub head assembly
(machine components, #5) is off the floor.
4. Sit in the Operator seat (machine components,
#11), hold the Steering wheel (machine
components, #12), press the Propel pedal
(machine components, #9) and driving slowly
the machine down from the slope.
InStallInG BatteRIeS
The machine uses the Lithium-ion batteries,
the batteries are already in the machine upon
delivery; However you will need to connect the
Lithium ion batteries to the machine.
WaRnInG: fire or explosion Hazard.
Keep sparks and open flames away! Keep
battery compartment open when charging.
1. Turn off the machine.
2. Open and prop up the Operator seat, plug the
batteries connector to the machine adaptor,
connect machine i-synergy
TM
COM port to the
batteries.
macHIne Set up
InStallInG BRuSHeS oR padS
1. Turn off the 1-Step switch (machine
components, #38) and raise the Scrub head
assembly off the floor, then stop machine on the
level surface, ensure the machine is turned off.
2. If using the pad driver, first attach the
appropriate pad to the pad driver surface.
3. Align the pad driver or brush under the motor
hub and push it upward to engage.
4. To remove the pad driver or brush, raise the
scrub head and remove the Side squeegee
assembly (machine components, #6), push the
edge of brush downward.
MACHINE SET UP & INSTALLATION
i-synergy
tm
IntRoductIon