Iccons GT6-IXF, Руководство пользователя

Страница: 6 / 20

6
ICCONS® GAS TOOL GT6-IXF USER MANUAL
damaged, disconnect the supply and stop
charging the battery immediately. If cable
or plug damaged, do not use for charging
battery. Contact authorized service agent
for replacement.
- Keep the charger exhaust area clean
and unblock to have the best cooling
effect. Use dry cloth to clean the body
and the contact of the charger while it
disconnected with the main power.
- Charge the battery in room temperature. If
the temperature is less than 0°C or greater
than 45°C will harm the performance or
degrade the battery.
- If the battery charger abnormally heats
up or gives off fumes during charging,
disconnect the power supply of the
charger immediately.
4.2 Safety For Handling Battery
- Do not short circuit the battery pack.
- Do not pierce or open the battery pack.
- Do not store the batteries at a temperature
above 50°C.
- Do not incinerate spent batteries.
- Only charge one battery at a time.
- Batteries and charging systems must be
recycled or taken to a designated disposal
area.
4.3 Battery Storage
- Store the batteries in a cool and dry place.
- Over-discharge will degrade the batteries
capacity. Fully charged the batteries if
stored for a long time. Recharge it in each
3 months can help to compensate the self-
discharged and keep the battery in a good
condition.
- The charging systems should store at a
place out of reach of Children.
- Always disconnect the batteries from tools
or charger while stored.
-
4 Use Of The Battery &
Charging System
READ INSTRUCTIONS
CLASS II DEVICE
FOR INDOOR USE ONLY
TIME-LAG FUSE-LINK
DISPOSE SEPARATELY FROM
HOUSEHOLD-TYPE WASTE
Introduction
- The adaptor, charger and the battery
are designed to operate together as one
system. Only use the
‘ICCONS® Pty Ltd’
Adaptor &
‘ICCONS® Pty Ltd’
Charger for
charging the
‘ICCONS® Pty Ltd’
Batteries.
- The charging system is intended to be
used in covered areas.
- Do not expose it to rain or to excessive
humidity.
- Do not recharge non-rechargeable
batteries.
4.1 Before Charging
- Arrange the supply cord appropriately
to avoid unnecessary damage, avoid
laying the supply cord across walkway or
doorway.
- When charging the battery pack, use
a specified battery charger. Check the
output and the polarity of the battery
charger are match with the battery pack
intended to charge.
- Check the system before use. Maintenance
and servicing are not required under
normal conditions. Do not dismantled the
battery charger or the battery pack.
- If the battery pack or charger enclosure is