Iccons GT6-IXF, Руководство пользователя

Страница: 4 / 20

4
ICCONS® GAS TOOL GT6-IXF USER MANUAL
Safety of the Fastener Driving Tool Cont.....
- Operator should carry out regular
maintenance (cleaning and lubrication) in
accordance with the operation manual to
keep the tool in good working order.
- The fastener driving tool should be
serviced properly and at regular intervals in
accordance with the operation manual.
2.3 Safety At Work
WARNING! Always assume the tool is loaded.
- Never point any tool at yourself or at any
other person.
- Make sure the workplace is clean and well
lit.
- Stay alert, watch what are you doing, and
use common sense when operating the tool.
Do not use tool while tired or under the
influence of drugs, alcohol, or medication.
- The tool must be carried pointed downward
while moving locations. Never carry the tool
with your finger on the trigger.
- Never press your hand on the front of the
tool. The tool must be operated only when it
is in contact with the material to be fixed.
- The operator must be in a stable position
when using the tool. Operate the tool in the
manner that should the tool recoil, there is
no risk of injury to the operator.
- When using the tool, the operator and any
bystanders must wear appropriate eye and
ear protection.
- When not in use, remove the battery, fuel
cell and fasteners, return the fastener
follower to guide locking position, and return
the tool to its carrying case.
2.4 Safety for Handling Fasteners
- Do not load the fasteners with the trigger
and/or work-contacting element pressed
- Ensure that you use the correct length of
fastener with the depth adjuster correctly
set, so that nails do not protrude when a
fixing is made.
- Do not drive fasteners on top of other
fasteners.
- Never drive fasteners into free space
or areas with concealed hazards. This
will avoid a hazard caused by free flying
fasteners and excessive strain of the tool.
Take particular care when nailing close
to edges as fasteners can break-out and
deflect out of the substrate.
- If tool jams or misfires, always remove the
battery and fuel cell prior to examination
of the tool. If the problem persists stop
operating the tool, unload the fasteners,
and contact the manufacturer or
authorized agents for service.
2.5 Safety for Gas-operated Nailer Tool
- The tool must not be used in a
combustible environment.
- The tool must be used in well-ventilated
areas. Exhaust gases in a confined space
can be hazardous. Do not use the tool
outside in the rain or where excessive
moisture in present.
- Keep the tool from heat sources as the
pressurized fuel cell could be damaged.
- Do not smoke when handling the fuel cell.
- Keep away from your face and eyes. Do
not inhale its content.
- The temperature of the tool may increase
depending on the firing frequency.
Observe the maximum cycle rates given in
the operating
instructions.
3 Use Of The Fuel Cell
Introduction
The fuel cell is an aerosol product
corresponding to the 2008/47/EC
regulations. It contains:
- Liquefied hydrocarbon gases (Butane & Propane).
- Lubricant to help tool work smooth.