EXCEL Canada
25
Owner’s Manual
ADJUSTABLE LENGTH (ELA18)
An adjustable chimney length is available for
chimney installations that require exact
lengths. An adjustable length can not be
installed immediately above a support,
elbow or tee. It can only be installed above a
straight length. When using the adjustable
length the flue (inside) does not adjust, only
the outside casing.
1.
Determine the required length.
2.
Remove the three screws from the outside casing of the adjustable
length. Slide the two sections of the outer casing together until the
required overall length is achieved.
3.
Using the stainless steel screws provided fasten the two sections of
outer casing together through the three pre-punched holes. The screws
are self drilling and will make their own holes. Cut off the exposed
insulation. The remaining insulation will compress enough to allow the
next chimney section to connect. Do not cut the inner flue, it will slide
inside the next chimney length.
4.
To install the adjustable length slide the flue into the length below until
the outside casing seats firmly in place. You may need to press firmly
to compress the additional insulation. Fasten the lengths together using
the 3 metal screws provided.
ANCHOR PLATE (EAP)
This support is used on a masonry fireplace to provide a positive
connection to the chimney. It is not to be used in contact with any
combustible material, such as a wood floor.
Once a fireplace is installed, bolt
the anchor plate to the fireplace.
Install the chimney according to
the Installation Instructions for the
Ceiling Support. Omit step 2 since
the anchor plate acts as the
chimney’s support.
Содержание EXCEL
Страница 32: ...Notes...
