EXCEL Canada
16
Owner’s Manual
3.
Slip the support down over the chimney - locate the support on the
chimney so that the required amount of chimney projects below the
finished ceiling - tighten the locking nut. Place the chimney in the
opening in the roof. Rotate the 90° brackets to adjust for the roof pitch.
Tighten the collar around the chimney, then secure it by screwing three
metal screws through the holes in the collar and into the chimney.
Tighten the four nuts which hold the brackets to the support band.
4.
Center the chimney in the hole in the roof and nail or screw the support
to the roof using 6 - 2 1/2" nails or # 8 x 1 1/2" wood screws.
OFFSET SUPPORT (EOS)
This support is used for re-supporting a chimney above an offset.
Install the chimney and elbows according to the installation instructions.
Install the support as follows:
See the table on page 3 to determine the minimum opening required for
the support. The chimney must have 2" of clearance all around.
1.
Assemble the band following the instructions on page 14.
2.
Bolt on the offset support straps - see diagram above.
3.
Slip the support down over the chimney to a convenient location.
4.
Tighten the collar around the chimney, then secure it by screwing three
metal screws through the holes in the collar and into the chimney.
5.
Attach the support straps to the floor or roof structure using two 3" nails
or #10 x 2" wood screws per strap.
6.
Continue installing the chimney.
Содержание EXCEL
Страница 32: ...Notes...