the outlet opening of the HM-12/HM-22/HM-22B;
Turn control knob to the
“off” position, the appliance should stop;
Press the reverse
button “turn over”, confirm that the screw feeder changes direction and starts
turning clockwise.
5 USING THE APPLIANCE
5.1 CONTROLS
FIG 4-Controls
1-Start button
“on”
2-Stop button
“off” 4-stop button (red)
3-Reverse button
“turn over” 5-start button (green)
5.2 SETTING UP THE HM-12/HM-22/HM-22B FOR USE
N.B
. Before using the appliance makes sure all the components that can be removed are secured in
position (see fig 6)
Mount the grinder outlet and block it into position using the handle located on the side of the
union;
Mount the screw feeder, blade and disk, and then screw on the lock nut.
5.3 FILLING THE GRINDER (see fig5)
When using the grinder it is important that you stand in the correct position.
Do not position yourself
so that any part of your body comes in direct contact with the grinder when working.
FIG 5-fitting the grinder
N.B
The grinder must be filled when working. The procedure to follow is:
1. Place the food in the tray;
2. Start the grinder using the start button.
3. Raise the pestle; feed the meat into the
tube; Without forcing use the pestle to push
the meat into the opening.
4. If the meat suitably cut beforehand there should be no
problems with the screw feeder,however,if there are problems
tighten the lock nut until the meat is cut to desired size.
5. To maximize disk and blade life and to maintain their sharpness in time:
- When all the meat has been ground, turn off the appliance;
- Blade and disk must always be coupled.
