ENGLISH
Icare ic200 tonometer manual
www.icaretonometer.com
6
TAKING THE DEVICE INTO USE
Before using the Icare ic200 tonometer for the first time, attach the wrist strap and insert the batteries.
INSTALLING THE WRIST STRAP
Thread the string loop at the end of the wrist strap through the two holes at the bottom of the device (see figure below). Take hold of the end of the wrist strap,
turn it back and bring it through the loop. Finally, pull the wrist strap to tighten the loop.
PRECAUTION
To avoid dropping the device and to ensure the safe handling of the device, always keep the tonometer attached to the wrist using the wrist strap when
operating the device.
INSTALLING THE BATTERIES FOR THE FIRST TIME
Unscrew the battery compartment locking screw with the screwdriver supplied. Remove the battery compartment cover. Insert a new set of four AA 1.5 V
batteries (LR6). Insert the batteries according to the figure below. Take care to observe correct polarity.
Replace the battery compartment cover. Secure the cover in place by tightening the locking screw. Take care not to use excessive force (torque) when tightening
the screw.
For a maximum grip in hand and traction on a slippery surface you may now install the silicone grip. Put it first over the end of the device and then slide it with a
firm grip all the way (rolling and finally unrolling the end of the silicone grip may help). Uninstall the silicone grip in reverse order.
PRECAUTION
Use only the battery type which is specified in technical specification section of this instruction manual.
1.
2.
3.
4.
All manuals and user guides at all-guides.com
all-guides.com