IC Realtime ICIP360L4, Быстрый старт

Страница: 11 / 17

6
Adjust the device chassis and pull the cable through the exit hole. Make “TOP” direction of the device
identical with installation diagram. Make sure the 3 fixture holes on chassis face the three plastic
expansion bolts on the surface. Take 3 self-tapping screws out from the accessories bag and fix them
on the three plastic expansion bolts to secure the dome on installation surface.
Step 4
Take up the dome protection enclosure; aim the cable exit and cover the enclosure. Then use the
inner hex wrench from the accessories bag to fasten the 3 hex screws. So far installation is completed.
Note:
Please refer to Micro SD card installation steps if you need to install Micro SD card, and operate step 4
after the installation.
Connect the host GND to ground lead, which may improve device reliability. The GND locates next to
exit hole on the rear side of the chassis and the GND screw is M3.
Figure 2- 2
2.2 Micro SD Card Installation
Take down the 3 hex screws on the upper enclosure by using the inner hex wrench in the accessories
bag, find the location of Micro SD card slot according to the following figure, and fasten the 3 screws
on the upper enclosure after inserting Micro SD card.
Note:
Please make sure the wire connection between power panel and device motherboard is firm,
otherwise may cause abnormity.
Make sure the 3 screws are fastened firmly after completion to prevent dust for the device.