IBM xSeries 440 8687, Руководство по техническому обслуживанию аппаратной части

Страница: 91 / 258

v The system scans PCI-X slots to assign system resources. The system attempts
to start the first device found. The search order is: CD-ROM, disk drives,
integrated SCSI devices, PCI-X slots (1, 2, 6, 5, 3, 4), and the integrated
Ethernet controller.
Note: You can use the Configuration/Setup Utility program to change the boot
precedence for the server. Select Start Options from the
Configuration/Setup Utility program main menu.
Adapter installation
Complete the following steps to install an adapter:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
electrostatic discharge-sensitive devices” on page 204.
1. Review the information in “Installation guidelines” on page 71, “Working inside
a server with power on” on page 71, and “Safety information” on page 201.
2. You must disable the Active PCI-X slots in the server using the operating
system before you insert or remove a hot-plug PCI or PCI-X adapter.
Note: Some operating systems do not support the enabling and disabling of a
PCI-X slot. If your operating system does not support this function, then
turn off the server, and disconnect all external cables and power cords
before proceeding.
3. Pull out on the quick release latches on each side of the server; then, pull the
server out of its rack enclosure until it stops.
4. Open the top cover.
Note: Inside the server there are six PCI-X slots: two 66 MHz, two 100 MHz,
and two 133 MHz. Before attempting to install a new adapter, be sure
there is an available slot for it. If you need additional PCI-X slots, you
can purchase a Remote Expansion Enclosure either from your IBM
Installing options
79