IBM XIV Gen3 Series, Руководство по планированию

Страница: 107 / 126

Figure 26 shows an extended manifold layout.
Flexible hoses and connections to manifolds and heat
exchangers
Pipe and hose configurations can vary. You can determine the best configuration
for your installation by analyzing the needs of your facilities, or a site preparation
representative can provide this analysis.
Flexible hoses are needed to supply and return water between your hard plumbing
(manifolds and cooling distribution units) and the heat exchanger, allowing needed
movement for opening and closing the rack rear door.
Hoses are available that provide water with acceptable pressure-drop
characteristics and that help prevent depletion of some corrosion inhibitors. These
hoses must be made of peroxide cured ethylene propylene diene monomer
(EPDM), non-metal-oxide material and must have Parker Fluid Connectors
quick-connect couplings at each end. These couplings are compatible with the heat
exchanger couplings. Hose lengths from 3 to 15 meters (10 - 50 ft), in increments of
3 meters (10 ft), are available. Hoses that are longer than 15 meters (50 ft) might
xiv10129
Figure 25. Typical central manifold (at a central location for multiple water circuits)
xiv10130
Figure 26. Typical extended manifold (located along aisles between racks)
Chapter 10. Planning for the rear-door heat exchanger
83