IBM TotalStorage DS4100, Инструкция по установке, использованию и обслуживанию

Страница: 40 / 180

Attention: The DS4100 single-controller storage server does not support
hot-swap RAID controllers or power supplies. You will lose access to data if you
attempt to remove or replace a functioning (non-failed) RAID controller or power
supply in a DS4100 single-controller storage server without first powering down the
storage server.
Hot-swap drive bays
The hot-swap drive bays that are accessible from the front of your storage server
are shown in Figure 2.
The DS4100 supports up to 14 DS4000 1.5 Gbps SATA hard disk drives. These
drives are preinstalled in drive trays. The unit consisting of the drive and the drive
carrier assembly is called a drive CRU . The SATA drive CRU includes the drive tray,
the SATA drive, and the hard disk drive (HDD) interposer card. You install the drive
CRUs in the 14 drive bays on the front of the storage server. There are no
serviceable parts in a drive CRU. If it fails, it must be replaced in its entirety (drive,
interposer, bezel, and tray).
Attention:
1. Never hot-swap a drive CRU when its associated green Activity LED is flashing.
Hot-swap a drive CRU only when its associated amber Fault LED lights and is
not flashing or when the drive is inactive and its associated green Activity LED
lights and is not flashing.
2. The SATA drive and its HDD card are digitally signed together at the factory. Do
not swap drives and interposers between drive CRUs. Do not replace one SATA
drive with another SATA drive. These actions will result in a drive CRU that
cannot be recognized by the storage server RAID controller.
3. After you remove a drive CRU, wait at least 70 seconds before replacing or
reseating the drive CRU to allow the drive to properly spin down. Failure to do
so may cause undesired events.
Note: If the hard disk drive you want to remove is not in a failed or bypass state,
always use the DS4000 Storage Manager client program either to place the
drive in a failed state or to place the array that is associated with the drive
(or drives) in an offline state before you remove the drive from the enclosure.
Front controls and indicators
This section describes the primary controls on the front of the storage server. The
locations of these primary controls are shown in Figure 3 on page 9.
Hot-swap drive bays
f10ug052
Figure 2. DS4100 hot-swap drive bays
8
IBM TotalStorage DS4100 Storage Server: Installation, User’s, and Maintenance Guide