IBM TotalStorage 3494 Tape Library, Руководство оператора

Страница: 492 / 605

Table 28. Intervention-Required Conditions (continued)
Intervention-Required Condition Resolution Actions
Message OP0024
The convenience I/O station should be empty but is
not, visually check the station.
Probable Cause
When the convenience I/O station Insert operation
completed, the cartridge-present sensor indicated that
cartridges were still present when none should have
been. A cartridge without a label in the station or debris
obscuring the cartridge-present sensor can cause this
condition.
1. Remove any cartridges from the convenience I/O
station and inspect their labels.
2. Remove any debris that may be obscuring the
cartridge-present sensor.
3. Check Convenience I/O in the System Summary
window to verify that the status is Empty .
Message OP0025
A cartridge could not be released from gripper x,
accessor y.
Probable Cause
The cartridge in gripper x, accessor y remained in the
gripper after an attempt was made to put it in a cell or
device. This may be because of a damaged cartridge,
alignment of the 3494 Tape Library, or a failing gripper.
The gripper remains available for use after the cartridge
is removed.
1. Place the 3494 Tape Library system in Pause mode.
2. Open the appropriate enclosure door.
3. Remove the cartridge from the indicated gripper.
4. Place the cartridge in the error recovery cell. The
error recovery cell is cell 1 A 1 (cell 1 A 3 if dual
grippers are installed in the 3494).
5. Close the enclosure door.
6. Place the 3494 Tape Library in Auto mode.
Message OP0026
A cartridge has been dropped.
Probable Cause
A cartridge has been dropped.
1. Open the enclosure.
2. Pick up the cartridge from the enclosure floor.
3. Put the recovered cartridge into the error recovery
cell. The error recovery cell is cell 1 A 1 (cell 1 A 3 if
dual grippers are installed in the 3494 Tape Library).
4. Close the enclosure.
5.
Place the 3494 Tape Library in Auto mode.
Message OP0028
An emergency stop has occurred.
Probable Cause
If an enclosure door is opened while the 3494 Tape
Library is in Auto mode, an emergency stop is
performed.
1. Determine what caused the stop. The usual cause is
an open enclosure door; check Enclosure doors in the
System Summary window to determine if one or
more doors are open.
2. Close the enclosure door.
3. Place the 3494 Tape Library in Auto mode.
466
3494 Tape Library Operator Guide