IBM System Storage TS7600 ProtecTIER Series, Инструкция по плану установки

Страница: 99 / 232

Table 22. Clustered Ethernet host connections for OpenStorage configuration (continued)
Callout From On Device To On Device/Location
10
Port 1, slot 4 Server B Designated device Customer's host network
11
Port 2, slot 4 Server B Designated device Customer's host network
12
Port 3, slot 4 Server B Designated device Customer's host network
Procedure
1.
Label and connect Ethernet cables (Cat 5e or higher) according to Table 21 on
page 59 and Figure 24 on page 59.
Notes:
Connection of the replication network cables is required only if the customer is
enabling the data replication feature.
2.
Label and connect Ethernet cables (Cat 5e or higher) according to Figure 25 on
page 60 and Table 22 on page 60 for the customers host network.
3. Go to “Clustered fibre channel connections.”
Clustered fibre channel connections
This task describes the fibre channel connections for theTS7650G server in a
clustered configuration.
About this task
Important:
This document references IBM 4.8 TB Fibre Channel Disk Controllers and IBM 7.2
TB Fibre Channel Disk Expansion Units in many of the hardware installation
figures, examples, and procedures.
In addition to the IBM DS4700 disk controller, the TS7650G also supports the
DS5000 disk controller, the DS8000 disk controller and the XIV disk controller, as
well as various non-IBM storage solutions. If the customer has elected to use disk
storage components other than the IBM disk controllers mentioned above, the
figures, examples, and procedures in this document will not apply to the
configuration on which you are working. Therefore, it is suggested that you
determine the make and model of the disk storage components in use and, if
necessary, obtain the related product documentation before you begin installation
of the gateway.
The RAS code no longer sends call home packages for problems with any of the
disk storage products attached to the gateway including DS4700. DS5000, DS8000
and XIV.
However, if the IP address of an SMTP server is provided during RAS package
configuration, the disk storage subsystems that communicate with the RAS
package (which includes DS4700 and DS5000 if they have firmware levels
supported by RAS) will send problem reports to the customer via email.
Chapter 4. Installing the TS7650G hardware
61
|
|