IBM System Storage TS7600 ProtecTIER Series, Инструкция по плану установки

Страница: 145 / 232

(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
10. Type:
q <enter>
The message below displays:
Would you like to commit the changes performed to the routing table
now? (yes|no)
11. Type: yes <enter> .
The
Successfully committed changes!
message displays, and you are
returned to the command prompt.
What to do next
After you have finished updating the OpenStorage interface settings, you will need
to install and configure the OpenStorage plug-in on your NetBackup media
server(s). To do so, refer to the instructions in the IBM System Storage ProtecTIER
User's Guide for Enterprise Edition and Appliance Edition, IBM form number
GC53–1156.
Configuring the OpenStorage application IP interfaces
This section describes how to update the OpenStorage IP communication interfaces
on a node.
About this task
Use the ./ptconfig -appInterfaces command to update the application-related IP
interfaces.
Note: Refer to the IBM System Storage TS7650 Best Practices Guide for ProtecTIER v
2.5 and TS7650G (Gateway) Attached Storage, IBM form number GA32-0646 for more
detailed information on updating the application-related IP interfaces.
Procedure
1. At the command prompt, change directories to launch the ptconfig utility for
the interfaces
cd /opt/dtc/install
and hit Enter.
2.
At the command prompt, enter the command:
./ptconfig -appInterfaces
The following output is displayed, for example:
# Interface L/B Method IP Address Netmask Devices
1 virt1 RR 10.10.1.1 255.255.255.192 eth5,eth6,eth9
2 virt2 RR 192.168.151.2 255.255.255.0
3 virt3 RR 192.168.152.2 255.255.255.0
4 virt4 RR 192.168.153.2 255.255.255.0
5 virt5 RR 192.168.154.2 255.255.255.0
6 virt6 RR 10.10.1.98 255.255.255.192 eth7
Available Options:
==================
(e)edit a virtual interface
Chapter 8. Configuring ProtecTIER using ptconfig
107
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|