IBM System Storage TS7600 ProtecTIER Series, Инструкция по плану установки

Страница: 128 / 232

2. Use ethtool to verify the that a link is detected and operational on each port, as
expected by the customer's network configuration. Enter the following
command for each port, replacing eth1 each time with the next port, i.e., eth2,
then eth3, then eth4, until you have checked all the ports:
Note: If some ports are not used in the customer's environment, such as the
replication ports, they may appear as not operational or have no link detected.
This is the expected result if the ports are not being used.
ifconfig eth1 up
# ethtool
eth1
3. Note the results of the above procedures and pass them on to the trained
ProtecTIER specialist/LBS representative for his or her use during ProtecTIER
configuration.
4.
Go to Chapter 7, “RAS verification,” on page 91.
90
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
|
|
|
|
|
|
|
|
|