IBM System Storage N3220, Инструкции по установке и настройке

Страница: 11 / 24

Using one silver pan head M5 screw, attach the rail to the front of the rack using hole H6. Tighten this
screw with a screwdriver.
3. At the rear of the rack, position the rail at the same EIA location used in step 2. Make sure that the
locating pins seat properly in holes H3 and H4. Using two silver pan head M5 screws, attach the rail
to the rack using holes H2 and H5. Tighten these screws with a screwdriver.
4. Tighten the four rail adjustment screws on the installed rail.
5. Repeat steps 2 through 4 for the left-hand rail.
6.
Repeat steps 1 through 5 for each additional N3220 that you are installing in the rack, making sure to
allow 2U of space for each N3220 filer.
Installing the N3220 filer in the rack
Use these instructions to install the N3220 filer in the rack.
18-32 kg (39.7-70.5 lbs)
svc00167
CAUTION:
The weight of this part or unit is 25.4 kg (56.0 lb). Use two people to lift an N3220 filer
into a rack.
1. If the N3220 filer front bezel is attached to the expansion unit, carefully remove the bezel by pulling
out on the rectangular openings (marked by blue stripes) on either side of the bezel.
2.
From the front of the rack, set the N3220 filer onto the rails and slide it into the rack until the front
mounting flange is a few inches from the rack frame. As shown in Figure 5 on page 4, position the
spacer plates
1
over the locating pins (holes H3 and H4) on the front left and right rails. Slowly
slide the chassis into the rack until the front mounting flange of the N3220 filer is flush against the
spacer plates.
H6
H5
H4
H3
H2
H1
1 EIA unit (1U)
Bottom rail screw
Top rail screw
REAR
Left and Right
Rails
Locating pins
Locating pins
Section of rack EIA rail
H6
H5
H4
H3
H2
H1
Bottom rail screw
Chassis attach screws
Chassis attach screws
FRONT
Left and Right
Rails
n340004
Figure 4. N3220 rail mounting template
Installation and setup instructions
3