IBM System Storage N3220, Инструкции по установке и настройке

Страница: 9 / 24

Installation and setup instructions
Use these instructions to install and set up your N3220 filer.
Unpacking the N3220 filer
Use these instructions to unpack the N3220.
Important: If your system was shipped already assembled and cabled in a rack, go directly to “Setting
up and booting the system in Data ONTAP 7-Mode” on page 10 or “Setting up and booting the system in
Clustered Data ONTAP” on page 11 depending on your configuration.
Each N3220 system enclosure ships with an accessories kit and set-up kit containing documentation and
hardware parts for installing your system. The quantity of hardware parts is determined by your system
configuration and requirements.
Each shipment container includes the following contents:
v
N3220 system enclosure
v N3220 system bezel
v
IBM System Storage N3220 Installation and Setup Instructions
v
General information kit, containing warranty, safety, and environmental information
v Software license
18-32 kg (39.7-70.5 lbs)
svc00167
CAUTION:
The weight of this part or unit is 25.4 kg (56.0 lb). It takes specially trained
persons, a lifting device, or both to safely lift this part or unit.
1. Remove the foam hardware protectors and the plastic surrounding the system.
2. Place the storage system on a table.
Contents for each N3220 model
The N3220 is a single-enclosure high availability (HA) capable system. Each N3220 model also ships with
at least one envelope with the software End User License Agreement (EULA) and license keys. The
following list describes the contents of the shipping packages included with the N3220 model:
v
Console adapters, RJ-45 to DB-9 (one per controller module)
v Cable management arms (two per controller module)
v
2 power cords
v Serial null modem cables (one per controller module)
v
2U IBM rail kit
v
1 ESD wrist strap
v 1 set of IBM publications
© Copyright IBM Corp. 2013
1