IBM System Storage N3220, Инструкции по установке и настройке

Страница: 15 / 24

Connecting the N3220 filer to a network
Use these instructions to connect the N3220 filer to a network. Perform the steps in this section for each
N3220 controller node.
Note: Use the cable management arms and hook-and-loop fasteners to organize your cabling.
1.
Connect the RJ-45 to DB-9 adapter (as shown in Figure 10) from the adapter kit to the console port on
the system.
2. Connect one end of the serial null modem cable to your console, and then connect the other end to
the DB-9 end of the adapter (as shown in Figure 10).
3. Perform one of the following steps depending on your configuration:
v
For 10/100/1000 setup in 7-Mode: Connect the system to the network by plugging the network
cables into the networking ports, labeled e0a, e0b, e0c, and e0d (Figure 11).
v
For 10 GbE setup in 7-Mode: Connect the system to the data switch (
3
in Figure 12 on page 8) by
plugging the network cables into the networking ports, labeled e1a and e1b (
1
in Figure 12 on
page 8).
Fibre
Channel
Console
Port labels
S
A
S
SAS
Ethernet
Management
Port
ACP
Port
n324026
e0b
e0d
e0a
e0c
LNK
LNK
0b 0a
!
+
-
LNK LNK
e1a e1b
ACT ACT
n324022
Figure 10. Cabling the console port
e0b e0d
e0a
e0c
LNK LNK
0b 0a
!
+
-
LNK LNK
e1a e1b
ACT ACT
n324024
Figure 11. Cabling the networking ports a 10/100/1000 setup in 7-Mode
Installation and setup instructions
7