IBM System Storage N3220, Инструкции по установке и настройке

Страница: 10 / 24

Installing the rails in an IBM 19-inch rack
Use these instructions to install the rails on which you will mount the N3220 filer.
Note: Read this document in its entirety before proceeding.
1. Loosen (but do not remove) the four rail adjustment screws on each rail, as shown in Figure 3.
2. Refer to Figure 4 on page 3. At the front of the rack, position the right-hand rail in the rack at the
appropriate EIA location. Make sure that the two locating pins seat properly in holes H3 and H4. The
bottom of the rail should line up with the bottom EIA boundary.
Note:
When installed, each N3220 will occupy a 2U space.
Right rail
Left rail
Front of rack
Rear of rack
Rail adjustment
screws
Locating pins
n620007
Figure 3. Installing the rails in the rack
2