![background image](http://html1.mh-extra.com/html/ibm/system-storage-7207/system-storage-7207_setup-operator-and-service-manual_4066817016.webp)
Media kit that includes:
SLR5-4GB data cartridge (conforms to the QIC-4GB-DC drive standard)
SLR5-4GBSL test cartridge
Cleaning cartridge
Step 2. Checking the Electrical Outlets
Make sure that the electrical outlets that you use are properly grounded.
Step 3. Running the Self Test
Run the self test to determine whether the 7207-122 Tape Drive is functioning
properly. To run the test:
1. If the 7207-122 Tape Drive is installed, remove it by performing steps 1-12
in Chapter 6, “Moving the 7207 Tape Drive” on page 37.
Note: Make sure that the SCSI cable and terminator are not attached to
the 7207-122 Tape Drive (or the self test may not function properly).
2. Set the SCSI address switch to 9 (see “Step 5. Setting the SCSI Address”
on page 6).
3. Attach the power cable to the 7207-122 Tape Drive, then plug it into an
electrical outlet. Make sure that the power to the tape drive is off.
4. Load the SLR5-4GBSL test cartridge into the 7207-122 Tape Drive (see
“Loading Tape Cartridges” on page 14).
Note: Use only the IBM test cartridge, part number 59H3661. Use of any
other test cartridge could cause erroneous test results or lengthen
the time needed to complete the test.
5. Press the 7207-122 Tape Drive power switch to turn on the power.
After approximately 5 minutes, the status light does one of the following:
Flashes green to indicate the completion of a successful self test. Unload the
test cartridge and press the 7207-122 Tape Drive power switch to turn off the
power. Store the test cartridge in a safe location (you may need it for future
diagnostics), then go to step “Step 4. Determining the SCSI Address” on
page 5.
Flashes red to indicate an error. Replace the 7207-122 Tape Drive.
4
7207 Tape Drive Setup, Operator, and Service Guide
Содержание System Storage 7207
